Drill Master 69652 Operations Instructions download pdf (Page 5)

ON/OFF SWITCH CONNECTION

The DrillMaster system uses P/N 14360 power

switch to turn the system on. If the P/N 14360

power switch is used, simply mount the switch

bracket as shown on page 4, and plug the

connector into the mating cable from the console.

Installation (continued)

Electrical Installation

This section explains how to connect your DrillMaster to

a 12-volt power source.

NOTE: The DrillMaster must be connected to a 12-

volt DC negative ground electrical system.

POWER/BATTERY CONNECTION

Locate the power cable for the DrillMaster and route

to the battery. When routing cable to console, avoid

areas where the cable may be subjected to abrasion

or excessive heat. Attach the BLUE wire (ground)

to a screw or bolt on the equipment frame. See

Illustration 3. Be sure there is a good metal-to-metal

contact. Connect the ORANGE wire to the positive

battery terminal. Connect the power to the DrillMaster

console by plugging the 2-pin W/P tower on the power

cable into the 2-pin W/P shroud of the display console.

Installation (continued)

Attaching the Speed Sensor

The DrillMaster uses an Astro 5 GPS

Speed Sensor. The speed sensor always

connects to the 3-pin M/P connector with

the yellow tie (on the back of DrillMaster).

Speed calibration entered into the

controller must be 0.189.

CrustBuster

DrillMaster Quick Start Guide

346-001150 Pg 5 Revised 11/2010

1 2 3 4 5 6 7 8 9 10 ... 34 35

No comments

Drill Master 69652 Operations Instructions Page 5