Drill Master 69652 Operations Instructions download pdf (Page 19)

Troubleshooting

Messages / Warnings

CAL

Typically indicates that defaults were entered by powering up with the CAL and

“-” buttons held, but calibration mode was not entered and exited. Cycling power

will not clear the bad CAL message, it can only cleared by entering and exiting

calibration mode.

Low Power. Check all power and ground connections.

One or more Seed Bins are near empty.

Warn LED ashes when the Rate error is over 10% in AUTO or if no ow input

(when there should be) in MAN. On steady when in CALIBRATE or

“SPECIAL”CALIBRATE or Test Speed.

“Special” Calibration mode is active. Appears when entering Special Calibration

mode (hold AUTO/MAN and CAL buttons while turning console on).

The message alerts the user that the currently selected counter will be cleared

if held for 2 seconds. Also serves as a reminder to use “+” button to select

counters.

Counters (DISTANCE or AREA or WEIGHT) have overowed their maximum.

RESET (see pages 26-27) to clear counters and resume counting.

Had an Emergency Stop. Check Seed Shaft (Flow) Sensor. Cleared by

turning all used Sections o, going to HOLD or cycling power.

Has loaded Default Cal factors (appears when default calibration factors are

loaded by holding CAL and “-” buttons while turning the console on).

In RATE mode and should have ow but no Flow is detected.

In Rows/Section Cal Mode, and no Sections are turned on.

In RATE mode and have no Speed, regardless of all other conditions.

In METER CAL TEST but have not yet enter a Test Speed.

Displays for 1.5 seconds upon powering up.

CrustBuster

DrillMaster Quick Start Guide

346-001150 Pg 19 Revised 11/2010

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 34 35

No comments

Drill Master 69652 Operations Instructions Page 19